Si related photodetectors and fiber optic sensing products - page 10
Si related products
InGaAs APD Photodiodes Φ200μm 950-1700nm TO-CAN
[InGaAs APD Photodiodes] 2024-01-21 03:04:11
InGaAs APD avalanche photodetector, wavelength: 950-1700nm; diameter Φ 200μm, used for distance measurement, spatial light transmission, LIDAR, low light detection, available in bare chip, TO-CAN, pigtail, flange and other packaging forms.
InGaAs Avalanche Photodiode 500um APD Chip
[InGaAs APD Photodiodes] 2024-01-21 03:03:35
This is a 500um diameter InGaAs APD photodetector, the wavelength range is 950-1700nm, Respondsivity at 1550nm is 0.9A/W, bandwidth 450MHz, we can provide die, but also according to customer packaging requirements for chip packaging, such as (TO package, pigtail package, etc.)
1550nm ultra-narrow linewidth single frequency laser ≤2kHz
[Laser Module] 2024-08-12 23:12:31
The center wavelength 1550nm ultra-narrow line width single frequency laser is a combination of silicon photonic chip technology, ECL laser technology and advanced packaging technology into a high-performance semiconductor laser products.
1550nm Butterfly SOA 14PIN
[EDFA] 2023-07-02 23:39:33
The series of products are based on the standard packaging platform of the Institute of Optoelectronic Integrated Microsystems, Tsinghua University, and use sealed inorganic butterfly device packaging technology
1550nm Narrow Linewidth Semiconductor Laser 100kHz 70mW DFB Butterfly Package
[Laser Module] 2024-01-14 09:03:15
Ultra-narrow linewidth (≤100 kHz), single-frequency center wavelength 1550nm, supports any wavelength customization in C-band, 14Pin butterfly package.
Si related articles
Data acquisition system for fiber optic vibration monitoring
From the schematic diagram we can see that the distributed fiber optic vibration data monitoring system, using a balanced photodetector for coherent detection, and then need to IQ demodulation of the collected data, demodulation followed by phase unwinding to obtain the amplitude root phase data information.
How to configure a pulsed laser for DTS temperature sensing
Introduces the configuration of the pulsed laser for DTS temperature sensing, including how to set the ACC and APC modes, the trigger method and the pulse width parameters.
What are DVS, DTS, DAS, FBG in fiber optic sensing
What are the DVS, DTS, DAS, FBG of fiber optic sensing, what are their technical features, and what are their main uses.
Fiber Optic Intrusion Detection System Video
The fiber optic perimeter intrusion monitoring system realizes fiber optic vibration sensing and monitoring based on the basic principle of Rayleigh scattering, combined with φ-OTDR (Phase Sensitive Optical Time Domain Reflection) technology and signal analysis and processing algorithms.
Raman amplifiers in distributed fiber optic acoustic sensing systems Video
Raman amplifier solves the problem of low signal-to-noise ratio in distributed fiber optic acoustic sensing DAS systems
Testing of a distributed fiber optic acoustic sensing system at a 50KM location
The PZT was used to test the Distributed Fiber Optic Acoustic Sensing System DAS at a location of 50KM, using a repetition frequency of 2000Hz, capable of testing signals at 980Hz.
Distributed fiber optic acoustic sensing system tests different vibrations with PZT and restores the signals.
Video of a test of the effect of a DAS-reduced signal using a PZT to generate vibrations of different frequencies for excitation of an optical fiber.
Fiber Optic Sensing Explained: How DVS (Amplitude) and DAS (Phase) Work, Differences, and Use Cases
Fiber Optic Sensing Explained: How DVS (Amplitude) and DAS (Phase) Work, Differences, and Use Cases
High-speed data acquisition card for DVS system
High-speed data acquisition card for DVS system，100MSps DAQ
Data acquisition card for distributed fiber optic vibration monitoring system
Introduction of data acquisition card for distributed fiber optic vibration monitoring system, 100M sampling rate, PCIe interface with demodulation algorithm.
YB-DAS-250-DAQ Distributed Fiber Optic Vibration Data Acquisition Card Description
YB-DAS-250-DAQ Distributed Fiber Optic Vibration Data Acquisition Card Description of how long the fiber optic length can be supported
Distributed Fiber Optic Sensing System
distributed fiber optic sensing systems have been widely used in various fields. Distributed fiber optic sensing system uses optical fiber as a sensing element, thus realizing distributed measurement of physical quantities.
What is the maximum distance of distributed fiber optic vibration sensing?
How long can a distributed fiber optic vibration sensing system monitor? In the laboratory it can support 80km, in the application site to consider the light decay and other reasons, the maximum available 60km.
What type of fiber is used for distributed fiber optic vibration sensing?
The type of fiber used for distributed fiber optic vibration sensing is single-mode G652, which is a very common fiber, all in our communication fiber optic cable, and is not expensive.
Component Configuration of a Distributed Fiber Optic Acoustic Sensing DAS
Distributed fiber optic acoustic sensing system DAS configuration of 2 ways, one is 80M AOM + 250M DAQ, the other is 200M AOM + 1G DAQ
Si fiber-coupled photodetector selection table Wavelength range 400-1100nm
List of fiber-coupled silicon photodetectors, wavelength 400-1100nm easy to quickly find the right product model.
Free-Space Si PIN APD detector, TO package for spatial light detection in visible light
Free-space silicon photodetector with response wavelength 400-1100 nm, including PIN amplification, APD and bias detector