Si related photodetectors and fiber optic sensing products - page 2
Si related products
Embedded Fiber Optic Vibration Sensor DAQ Card
[DAQ] 2024-02-01 04:52:10
Comes with an ATOM CPU, 4G of RAM, and is capable of running an operating system. Reads DAQ data through the built-in PCIe interface, and supports data transfer through the network port.
Embedded 8-channel Dynamic Signal Acquisition Card DAQ
[DAQ] 2024-02-01 07:35:15
High-performance K7 FPGA chip on board, connected to the CPU through the PCI Express 2.0 bus, which can realize fast real-time transmission of acquisition data, and the maximum sampling rate of the acquisition card is 204.8KSps.
DAQ for Raman DTS with Ethernet interface 250MSps pulse-triggered output
[DAQ] 2024-06-10 09:50:43
The GY-DTS-X is a special DAQ card for DTS system，With 100/200/250MSps sampling rate. It adopts 100Mbps network port for data transmission，Built-in averaging function with a high signal-to-noise ratio. the maximum number of averaging can be up to 65536 times.
DVS/DAS Integrated Optical Module
[DVS Module] 2025-04-03 00:33:46
YB Photonics’s DVS/DAS integrated optical module highly integrates inside our own proprietary ultra-narrow linewidth laser, pulsed EDFA, Raman amplifier, AOM and other optical components in single compact package.
Distributed Optical Fiber Vibration Sensor Module (DVS Module)
[DVS Module] 2025-04-05 01:13:51
The DVS integrated module of distributed fiber optic vibration sensing system integrates ultra-narrow linewidth light source, AOM acousto-optic modulator, pulsed EDFA, optical circulator, Raman amplifier, DVS coherent receiver module, etc., which only needs to be matched with a high-speed data acquisition card to make a set of DVS distributed vibration measurement system.
Si related articles
Data acquisition system for fiber optic vibration monitoring
From the schematic diagram we can see that the distributed fiber optic vibration data monitoring system, using a balanced photodetector for coherent detection, and then need to IQ demodulation of the collected data, demodulation followed by phase unwinding to obtain the amplitude root phase data information.
How to configure a pulsed laser for DTS temperature sensing
Introduces the configuration of the pulsed laser for DTS temperature sensing, including how to set the ACC and APC modes, the trigger method and the pulse width parameters.
What are DVS, DTS, DAS, FBG in fiber optic sensing
What are the DVS, DTS, DAS, FBG of fiber optic sensing, what are their technical features, and what are their main uses.
Fiber Optic Intrusion Detection System Video
The fiber optic perimeter intrusion monitoring system realizes fiber optic vibration sensing and monitoring based on the basic principle of Rayleigh scattering, combined with φ-OTDR (Phase Sensitive Optical Time Domain Reflection) technology and signal analysis and processing algorithms.
Raman amplifiers in distributed fiber optic acoustic sensing systems Video
Raman amplifier solves the problem of low signal-to-noise ratio in distributed fiber optic acoustic sensing DAS systems
Testing of a distributed fiber optic acoustic sensing system at a 50KM location
The PZT was used to test the Distributed Fiber Optic Acoustic Sensing System DAS at a location of 50KM, using a repetition frequency of 2000Hz, capable of testing signals at 980Hz.
Distributed fiber optic acoustic sensing system tests different vibrations with PZT and restores the signals.
Video of a test of the effect of a DAS-reduced signal using a PZT to generate vibrations of different frequencies for excitation of an optical fiber.
Fiber Optic Sensing Explained: How DVS (Amplitude) and DAS (Phase) Work, Differences, and Use Cases
Fiber Optic Sensing Explained: How DVS (Amplitude) and DAS (Phase) Work, Differences, and Use Cases
High-speed data acquisition card for DVS system
High-speed data acquisition card for DVS system，100MSps DAQ
Data acquisition card for distributed fiber optic vibration monitoring system
Introduction of data acquisition card for distributed fiber optic vibration monitoring system, 100M sampling rate, PCIe interface with demodulation algorithm.
YB-DAS-250-DAQ Distributed Fiber Optic Vibration Data Acquisition Card Description
YB-DAS-250-DAQ Distributed Fiber Optic Vibration Data Acquisition Card Description of how long the fiber optic length can be supported
Distributed Fiber Optic Sensing System
distributed fiber optic sensing systems have been widely used in various fields. Distributed fiber optic sensing system uses optical fiber as a sensing element, thus realizing distributed measurement of physical quantities.
What is the maximum distance of distributed fiber optic vibration sensing?
How long can a distributed fiber optic vibration sensing system monitor? In the laboratory it can support 80km, in the application site to consider the light decay and other reasons, the maximum available 60km.
What type of fiber is used for distributed fiber optic vibration sensing?
The type of fiber used for distributed fiber optic vibration sensing is single-mode G652, which is a very common fiber, all in our communication fiber optic cable, and is not expensive.
Component Configuration of a Distributed Fiber Optic Acoustic Sensing DAS
Distributed fiber optic acoustic sensing system DAS configuration of 2 ways, one is 80M AOM + 250M DAQ, the other is 200M AOM + 1G DAQ
Si fiber-coupled photodetector selection table Wavelength range 400-1100nm
List of fiber-coupled silicon photodetectors, wavelength 400-1100nm easy to quickly find the right product model.
Free-Space Si PIN APD detector, TO package for spatial light detection in visible light
Free-space silicon photodetector with response wavelength 400-1100 nm, including PIN amplification, APD and bias detector